Installing photo frame hardware may be difficult if you don’t know just what you’re doing. That’s why most quality dangling photo frames have frame equipment contained. The important thing first step before you install your image frame hardware is to make certain you choose the right kind and size of hardware. Both most common types of frame equipment are saw teeth braces and eye hooks. For picture frames smaller compared to 11 x 14, it is greatest to go with a power saw tooth hanger. That’s a jagged, power saw tooth shaped rectangular hanger that you install in the middle point of your frame.
Ensure you know which way you need the image to hang, and after that position the hanger in the middle, toward the top 3rd part of the frame. If you don’t know where middle of the frame is, utilize a tape measure and put a dot in the middle point, then put the saw tooth hanger over it, maintaining it as centered as possible. You may also need to utilize a degree to make sure that the hanger is even with the type of the frame. Eye hooks have been screwed into the wood of the frame and have been greatest for heavy or big picture frames.
These take more time to install than the usual saw tooth hanger, but could be done with some effort. Each eye hook will go on the side of the frame about 1\/3 of the way down from the top of the frame. Make a mark on the rear of the frame where the screw will go and after that use a tape measure to measure the distance from the crest of the frame to where you installed the eye hook. Then take this dimension and used for determine where the second screw will be positioned on the opposite side of the frame.
This way both screws may be the very same distance from the crest of the frame. Once you’ve where your screws may be placed, pre drill two really small holes to make it simpler to install the screws. After the screws have been in place, take a string of cable and stretch it between the eye hooks. The cable must make a triangular form and not exceed the upper part of the frame.